Table of Contents
What is AMBA AHB?
This chapter describes the Advanced High-performance Bus (AHB) architecture. Bus interconnection. Overview of AMBA AHB operation. Basic transfer.
What is pipelined operation in AHB?
The AHB architecture is based on separate cycles for address and data. During this data cycle, the address and control for the next transfer are driven out. This leads to a fully pipelined address architecture. When an access is in its data cycle, a slave can extend an access by driving the HREADY signal LOW.
What is the purpose of AHB?
Comparison Table Between AHB and APB
| Parameters of Comparison | AHB | APB |
|---|---|---|
| Used for | It is used for both low as well as high bandwidth control accesses. | The Advanced Peripheral Bus will only be utilized for limited latency control accesses as contrasted to the Advanced High-performance Bus. |
What is the use of the AMBA interface and where is it present in the architecture?
Advanced eXtensible Interface (AXI) AXI, the third generation of AMBA interface defined in the AMBA 3 specification, is targeted at high performance, high clock frequency system designs and includes features that make it suitable for high speed sub-micrometer interconnect: separate address/control and data phases.
Where is AMBA used?
Today, AMBA is widely used in a range of ASIC and SoC parts. These parts include applications processors that are used in devices like IoT subsystems, smartphones, and networking SoCs.
What is 1k boundary in AHB?
1 kilobyte is the smallest area an AHB slave may occupy in the memory map. Therefore,if a burst did cross a 1 kilobyte boundary, the access could start accessing one slave at the beginning of the burst and then switch to another on the boundary, which must not happen for the above reason.
What is the difference between AXI and AHB?
AHB is Advanced High-performance Bus and AXI is Advanced eXtensible Interface. The AHB is also a shared Bus whereas the AXI is a read/write optimized bus. In AHB, each of the bus masters will connect to a single-channel shared bus.
What is the use of AMBA bus in arm?
The Advanced Micro controller Bus Architecture (AMBA) bus protocols is a set of interconnect specifications from ARM that standardizes on chip communication mechanisms between various functional blocks (or IP) for building high performance SOC designs.
What is AMBA in VLSI?
The Advanced Microcontroller Bus Architecture (AMBA) is an open System-on-Chip bus protocol for highperformance buses to communicate with low-power devices.
What is the Amba APB protocol?
AMBA has several versions including AHB, APB, AXI etc. AHB, AXI are high performance system buses used for interconnecting CPU cores, DMA etc. Hence due to the wide scale usage of AMBA APB protocol it is essential to reduce the verification time to meet design time constraints.
What is Amba AHB?
The AMBA AHB is designed f or high-performance, high-clock s ystem modules. ”The“ AHB acts as the syste m’s high-performance backbone bus. AHB supports t he interfaces. All signal transitions relate only to the rising clock design flow.
Is there an amba APB design verification IP(VIP)?
This paper presents the architecture of the AMBA APB bus protocol and verifies the design using a custom built UVM based testbench to develop a standard AMBA APB verification IP(VIP) and discuss the obtained results. Keywords: AMBA, VLSI, VIP, SoC, APB, UVM, Design Verification.
What is the architecture of AMBA bus?
As seen in the Figure.1, AMBA bus architecture consists of three components, namely Advanced High Performance Bus (AHB), Advanced System Bus (ASB), Advanced Peripheral Bus (APB)[3]. AMBA AHB or ASB is high performance bus and has higher bandwidth.
https://www.youtube.com/watch?v=bEF8eXZZt7k