How can I make a hole in my belt?

How can I make a hole in my belt?

Method 1: Hammer and Nail (or an Awl) That’s right, all you need is a hammer and nail to get the job done. Even the simplest of toolboxes will have this. Simply find a nail that is similar in size to the holes on your belt, line it up with the mark for your new hole, and drive it through with the hammer.

Can you poke a hole in a belt?

At times we have all have had to make the extra holes on a belt ,when you start punching a hole in a belt you must ensure the belt punchers is strong enough to make the pressure of making the hole in your belt as a guide You are best to buy the highest quality leather punch pliers you can.

How do I make more holes in my leather belt?

Take the belt off and secure it, good side up, to a piece of wood, using strong tape to hold it in place if necessary. Find a nail of a similar size to the existing holes. Place the nail over where you want the new hole to be and hammer it through the leather. For neatness, try to do this in as few hits as possible.

How do you punch a hole in a belt without a leather punch?

Keep your belt stretched firmly (you can hold one side of the belt under you foot, and the other side with one of your hand, while the other hand is holding the pliers) and point the nail to the spot you want to make a hole, and push into the belt. It makes a small regular hole very easily.

How do you make a hole in a fabric belt?

You can put small holes in your belt with a sharp knife, scissors, or even a screwdriver. Make sure your holes are evenly-spaced and aligned in the middle of your belt fabric. Don’t leave the edges of your holes frayed — this will make them vulnerable to wear and tear. Instead, use an eyelet or a buttonhole stitch.

How do you make a belt loop?

How To Make Belt Loops

1. Fold your fabric in half lengthwise wrong sides touching.
2. Unfold the fabric, then press each long edge into the center fold line.
3. Fold in half again lengthwise, press and pin.
4. Edgestitch along the long edges of both sides of the strip to close the loop and create some decorative topstitching.

Can you drill through paper?

A paper drill cuts clean holes through large stacks of paper without causing damage. A large quantity of paper sheets can be difficult to press through with a standard hole punch. Drilling into paper with a handheld drill may cause uneven holes, tears and even heat burns.

What’s the best way to add holes to your belt?

Put the belt around your waist and determine the area on the belt where you need to add the hole. Mark this area by drawing a small dot that is parallel to the other belt holes. Lay the belt flat on a piece of wood with the outside part of the belt facing up.

Turn the belt over and cut off the leather that has poked through on the other side using a sharp knife. Use clear shoe polish to seal the inside of the hole you have created – a toothpick is handy to apply the polish to the sides.

How can I add holes to a leather belt?

Gather Materials

Measure Out the Holes. To keep the belt consistant you are going to want to measure out the exsisting holes.

Creating the Hole

Cleaning Up the Hole

Finnished. Now you can fix all those belts you have that are too big to wear. Did you make this project? Share it with us!

What are holes in a belt called?

The holes in a belt are officially named “Belt Holes”.