Table of Contents
How do I connect two speakers with aux?
How to – Speakers – Play via AUX Input
- Insert one end of the AUX cable into the AUX input on the bottom of your speaker.
- Insert the other end of the AUX cable into the AUX output port on your audio device.
- Turn the SOURCE knob to AUX, then push once to activate.
Why is only one of my speakers working in my car?
When all of the speakers in a car audio system all stop working at once, the problem is usually in the head unit, in the amp, or in the wiring. In some cases, an issue with the wiring between the head unit and a single speaker can even cause all of the speakers in an entire car audio system to cut out at once.
How can I use Aux in stereo?
How to connect a portable audio player to a stereo system using an audio cable.
- On the portable player, connect the appropriate end of the audio cable to the HEADPHONE or LINE OUT jack.
- On the stereo system, connect the audio cable to the LINE IN, AUX IN, or REC IN jack.
Why does my iPhone only play out of one speaker in my car?
If your iPhone’s audio settings are improperly configured, you’ll likely hear one-sided playback. Turn off mono audio from the “Accessibility settings” to allow a left and right playback. With mono audio, all the sound signals, both left and right are mixed into one signal and routed through one channel (speaker).
Why won’t My AUX cable work on my stereo?
Check to see if the AUX cord is firmly connected to both devices. If this does not work and are only two rings, your cord is not compatible. If there are three rings, replace the auxiliary cord. If this does not work, the problem may be with the auxiliary cord jack and you may need to replace it.
How do you connect two speakers together?
Android users need to go to Bluetooth Settings and pair either Bluetooth headphones or speakers one by one. Once connected, tap the three-dot icon on the right and click on Advanced Settings. Toggle on the ‘dual audio’ option if not already turned on. This should enable users to connect to two devices at once.
Why are my rear speakers not working?
Verify that the rear surround speakers are properly connected to the Audio/Video (A/V) receiver. Increase the rear speaker volume or surround speaker settings to maximum. Try selecting a different size (small or large) for the rear surround speakers in the menu.
Why is there no sound coming out of my car speakers?
The most common reason for no sound is speakers or speaker wires are grounded or shorted to a metal point. Speaker wiring cannot be wired together. Two speakers can not share the same connections. Speaker wiring cannot be wired to a chassis ground.
How do I connect my aux to phono?
Connect the ground wire from your turntable to the metal screw on the phono preamp to remove any hum or buzz sounds. Connect a pair of RCA cables into the “Output” RCA connections on the preamp and connect to the Aux input on the back of the receiver.
How do I get my iPhone to play sound on both speakers?
How to Make Both Speakers Work on an iPhone
- Turn the volume all the way up on the phone by pressing the volume control on the side of the phone.
- Find a small, fine needle.
- Turn the phone upside down and locate the speaker on the bottom of the phone.
- Take the pin and place it into the speaker one time.