How do I fix my Seagate external hard drive not responding?

How do I fix my Seagate external hard drive not responding?

Basic hardware troubleshooting steps:

1. Try connecting the drive to a different port on the computer.
2. If possible, try using a different cable.
3. Try using the drive on a different computer.
4. Verify the drive light is on.
5. Try a different power outlet.

How do I fix my external hard drive that won’t read?

What to Do When Your External Hard Drive Won’t Show Up

1. Make Sure It’s Plugged In and Powered On. Western Digital My Book.
2. Try Another USB Port (or Another PC)
3. Update Your Drivers.
4. Enable and Format the Drive in Disk Management.
5. Clean the Disk and Start From Scratch.
6. Remove and Test the Bare Drive.

How do I fix my Seagate external hard drive?

Quick tips to fix problematic Seagate external disk:

1. Try a different USB port on the computer.
2. Switch to a new cable if the current one is damaged.
3. Try connecting the drive to a different computer.
4. Verify if the drive’s light is on.
5. Try a different power outlet.

How do I reset my Seagate external hard drive?

Reset using the button

1. Power down the Seagate Central by unplugging it from power.
2. Wait approximately 15 seconds.
3. Power up the Seagate Central again.
4. Wait for the device to fully boot and show a steady, non-blinking green light. This takes about three to four minutes.
5. Wait until the light becomes solidly illuminated.

What do I do if my internal hard drive is not detected?

To check to see if this is the cause of the BIOS not detecting the hard drive, follow these steps:

1. Power off the computer.
2. Open the computer case and remove the data cable from the hard drive. This will stop any power saving commands from being sent.
3. Turn on the system. Check to see if the hard drive is spinning.

Why does my Seagate drive not show up?

If your Seagate external hard drive is detected, the original cable is the cause. If the problem still appears, connect the external hard drive to another USB port. Then, check whether the Seagate external hard drive is recognized. If so, it can be concluded that there is something wrong with the previous USB port.