Table of Contents
How do you make something sound far away when mixing?
A lower mix, or more dry, sounds closer, higher mix or more wet sounds farther away. If you want to create a better illusion of distance, playing with the pre-delay setting for the reverb can help.
How do I get logic to follow playhead?
In the Logic Pro > Preferences > General > Catch pane, you can set the following options:
- Catch when starting playback: Turns on Catch mode whenever you click Play or Pause.
- Catch when moving playhead: Turns on Catch mode whenever you move the playhead.
How do I nudge audio in Logic?
Nudge regions by the nudge value
- In Logic Pro, select the regions you want to move.
- Press and hold Option and press the Left or Right Arrow key.
How do I activate track in logic?
In Logic Pro, click the On/Off button in the track header. If the On/Off button is not visible, you can show it or configure track header components. To turn the track on, click the On/Off button again.
How do you move the playhead?
To move the playhead forwards by frames, press Ctrl/Cmd-Num + or Ctrl/Cmd-F9. To move the playhead backwards by frames, press Ctrl/Cmd-Num – or Ctrl/Cmd-F7. Click Fast Forward in the Transport window to navigate forwards. Click Rewind in the Transport window to navigate backwards.
How do you spread a stereo?
Stereo Spread extends the stereo base by distributing a selectable number of frequency bands from the middle frequency range to the left and right channels. This is done alternately—middle frequencies to the left channel, middle frequencies to the right channel, and so on.
How do you automate a stereo in logic?
1. in the Mixer, select Output channel strip, then click on Options > Create Arrange Tracks for Selected Channel Strips. 2. Go back to the Arrange Window, press A and start automating the new track called Output.
How to compress vocals in Logic Pro?
Use the loop control in Logic to select a section of vocals, and open up the compressor plugin. Start with a modest ratio of 2:1-4:1 (4:1 is generally seen as the middle ground in compression ratios). Roll back the threshold control until the compressor starts engaging when the loud vocals kick in.
How do you use Autotune in Logic Pro X?
In a time before Autotune *gasp*, USB microphones and digital audio workstations like Logic, mixing a track was an incredibly complex and laborious activity. In minutes, you can use Autotune in Logic Pro X to clean up a vocal track, switch to the Scissors tool to make some quick cuts, and apply automation in an instant.
What is EQ in Logic Pro and how to use it?
Here’s what you need to know about using EQ in Logic Pro. EQ is the process of manipulating the frequency spectrum of a track, and is used to either cut offensive frequencies, or boost desired ones. Logic has 5 built in EQs, the most commonly used of which is a parametric EQ called Channel EQ.