Table of Contents
How strong would you have to be to punch a hole through someone?
A quick ballpark The means your punch would have to be about 480 lbs force – sustained through the punching depth from front to spine of about 8 inches. In reality, punching a person this hard would not be enough because the shear strength will be offset by compression of the targets flesh and momentum transfer.
Where do you punch someone to make them unconscious?
Some of the most common strikes to attack the jaw area with sufficient force to cause the knockout include:
- the cross.
- the hook.
- the uppercut.
- the rising knee.
- the front kick.
- the forward or spinning elbow.
How much force does it take to punch through steel?
While there are different types of steel with different ultimate tensile strengths, you can take 40,000psi (40,000 pounds per square inch) as a reasonable average number.
Can a human punch through a wall?
A very wall placed blow may be able to punch into the core of a hollow CMU block, or again you might dislodge a poorly constructed brick, but as a general rule even very strong and trained people aren’t going to be able to punch through typical walls at will.
Can a human punch through a human?
No, it’s not possible. at most, an extremely powerful punch can break bones and do some internal damage. but not pierce or go through someone’s chest. a fist is too large, to go through someone’s chest you need to concentrate more energy on a smaller and harder object.
Can humans punch through steel?
In this idealized case, we can compute an approximation of the necessary velocity of an non-deformable human fist backed up by the entire weight of the unbreakable unbendable human to punch through: The shear strength of steel is about 350 to 1400 MPa (50,000 to 200,000 psi).
How thick can steel be punched?
Chart showing Tonnage Required to Punch a Hole
| Round Hole Diameter to be punched | ||
|---|---|---|
| Steel Thickness | 1 inch (25.4mm) diameter | 1-1/8 (28.6mm) |
| 16 gauge (.060) | 5 tons | 5.5 |
| 12 ga. (.105) | 8 | 9.5 |
| 10 ga. (.135) | 10 | 12 |
How many pounds of force does it take to punch through a wall?
Ever wondered how much force it takes to punch through a sheetrock wall? MissBusters did a study by assuming the distribution was normal. They randomly selected 5 walls and found it took an average of 3.22 Newtons with a standard deviation of 0.81 Newtons to break through a standard sheetrock wall.