Table of Contents
What is Cutoff Voltage in BJT?
Whenever we observe the terminals of a BJT and see that the emitter-base junction is not at least 0.6-0.7 volts, the transistor is in the cutoff region. In cutoff, the transistor appears as an open circuit between the collector and emitter terminals. In the circuit above, this implies Vout is equal to 10 volts.
What is difference between BJT and FET?
The major difference between BJT and FET is that in a field-effect transistor only majority charge carries flows, whereas in BJT both majority and minority charge carriers flow….Difference between BJT and FET.
| BJT | FET |
|---|---|
| BJT gain is more | FET gain is less |
| Its output impedance is high due to high gain | Its output impedance is low due to low gain |
What is FET voltage?
It has a structure akin to a MOSFET coupled with a bipolar-like main conduction channel. These are commonly used for the 200–3000 V drain-to-source voltage range of operation. Power MOSFETs are still the device of choice for drain-to-source voltages of 1 to 200 V.
What is cut out voltage?
In electronics, the cut-off voltage is the voltage at which a battery is considered fully discharged, beyond which further discharge could cause harm. …
What is current cutoff?
In electronics, cut-off is a state of negligible conduction that is a property of several types of electronic components when a control parameter (that usually is a well-defined voltage or electric current, but could also be an incident light intensity or a magnetic field), is lowered or increased past a value (the …
What is pinch off voltage?
Pinch-off voltage may refer to one of two different characteristics of a transistor: in junction field-effect transistors (JFETs), “pinch-off” refers to the threshold voltage below which the transistor turns off. the pinch off voltage is the value of Vds when drain current reaches constant saturation value.
Why FET is called voltage control device?
FET is a voltage-driven/controlled device, i.e. the output current is controlled by the electric field applied. The current through the two terminals is controlled by a voltage at the third terminal (gate). It has a high input impedance. So, a FET is a voltage-controlled current source.
What is BJT circuit?
A bipolar junction transistor (BJT) is a type of transistor that uses both electrons and electron holes as charge carriers. In contrast, a unipolar transistor, such as a field-effect transistor, uses only one kind of charge carrier. Hundreds of bipolar junction transistors can be made in one circuit at very low cost.
Whose voltage gain is higher BJT or FET?
FETs offer greater input impedance than BJTs. This means that they practically draw no current and therefore do not load down the power circuit that’s feeding it. BJTs offer greater gain at the output than FETs.
What is cut off voltage and breakdown voltage?
The reverse voltage at which P-N junction of a diode breaks down with sudden rise in reverse current is known as break down voltage. The forward voltage at which the current through the junction starts increasing rapidly, is called the knee voltage or cut-in voltage.