What is Ddrc in AVR?

What is Ddrc in AVR?

DDR stand for data direction register. C indicates the port name. So DDRC instruction is used to set direction of data for port C. If you want to set port C as an output port then use DDRC 0xff. If you want to set port C as an input port then use DDRC 0x00.

What is 0xFF in microcontroller?

0xFF is the hex representation of ~0 (i.e. 11111111) In, for example, VB and Access, -1 is used as True.

What is the purpose of the Ddrb register in the AVR chip?

This register is used to read the data from the port pins. Before reading the data from the port pins, the ports needs to be configured as Inputs. DDRB = 0x00; // Configure the PORTB as Input.

What is Ddra in embedded system?

DDR (Data Direction Register) • DDR decides whether the pins of a port are. input pins or output pins. • If the pin is input, then the voltage at that pin.

What is the concept of X Y and Z register in AVR?

XYZ is a pointer register, either X or Y or Z. YZ is a pointer register, either Y or Z. s is a bit number in the status register (0 = C, 1 = Z, etc., see the list above) b is a bit number in a general-purpose or I/O register (0 = least significant, 7 = most significant)

What is the clock source for the timers?

1. What is the clock source for the timers? Explanation: Timer’s clock source is the crystal that is applied to the controller.

What is input port and output port?

(1) (Input/Output port) An I/O port is a socket on a computer that a cable is plugged into. The port connects the CPU to a peripheral device via a hardware interface or to the network via a network interface. (2) (Input/Output port) In a PC, an I/O port is an address used to transfer data.

What does 0xFF mean on a DDR port?

DDR stands for Data Direction Register. In this case, you are talking about DDR for Port C and changing the direction of the port pin. By writing 0xFF, you are making all the pins as output. I found this link on AVR covering basics of GPIO.

What is the use of the DDRC instruction in microcontroller?

C indicates the port name. So DDRC instruction is used to set direction of data for port C. If you want to set port C as an output port then use DDRC 0xff. If you want to set port C as an input port then use DDRC 0x00. It will set all 8 pin of port C as input or output. If you want to control individual pin that is also possible.

What is the difference between 1 and 0 in DDRX?

Always remember, in the case of DDRx, 1 stands for output and 0 stands for input. In the following statement (given below), port C is initialized such that the pins PC0, PC4, PC5 and PC7 are output pins whereas pins PC1, PC2, PC3 and PC6 are input pins.

What is DDRx (Data Direction Register)?

The DDRx (Data Direction Register) helps in it. DDRx initializes the port. Have a look at it’s bit structure. The ‘x’ in DDRx is just for representation. It is replaced by the corresponding port i.e. x = A, B, C, D. Say for the example shown in the diagram above So, did you get how to declare it?